Practool News

CLAMP-IT Mix-it Range

Any size in any size out any size off!!!!

Get rid of that big pile of useless fittings that don’t fit or don’t match

Using the Mix-it Range :- Just 6 pieces will combine to make 30 different Fittings!

Mix-it Range

How does it work?

  1. Decide on the fitting required (eg. Tee Elbow or Reducer)
    Hint: Use 1 ½” BSP Threaded Fittings
  2. Select tails to suit pipe size
    Hint: 1 ¼”, 1 ½” & 2” Tails all have 1 ½” BSP threads on the other end
  3. Check o ring is in place on tail. Screw the selected tail into fitting
    Hint: recommended fittings have a chamfer for an o ring seal, other
    fittings can be used but require thread tape .Nip tighten for best seal.
    Do not over tighten.
  4. Slide the pre-made stainless steel wire clamps on to the pipe
  5. Insert fitting
    Hint: Tail slips inside poly pipe.
  6. Tighten clamp with CLAMP-IT Tool
    Hint: Use second tail to position wire clamp before tightening.
    Tighten clamps to within ½” of the full length of the CLAMP-IT Tool
  7. 6 Flip the CLAMP-IT Tool over 180 degrees, cut wire to 6mm
    Hint: Pushing ends in beside each wire wrap gives a smooth, safe finish

Cheaper
The MIX-it Range is much cheaper as you do not need to carry such a big range. Using 6 pieces you can create virtually any fitting.
Save Time
Always have the right combination on hand. Fittings are adjustable
Hint Use 1 ½” Socket with 2 tails and make an extra long Adjustable Joiner 12” long.
Tested
O ring seal tested to 100psi.
Rust proof
The Tails are made of toughened plastic while the wire clamps are 316 marine grade 1.6 stainless steel.

Tails available in 3 sizes to suit Rural Poly Pipe.

Kit

Tail Size

 

Price*

1

2.00 inch Tail

Purchase

$8.80

2

1.50 inch Tail

Purchase

$6.60

3

1.25 inch Tail

Purchase

$4.40

Kit

Fittings

 

Price*

4

Socket

Purchase

$4.60

5

Elbow

Purchase

$4.60

6

Tee

Purchase

$6.40

Cost is AUD$ and includes GST, but not freight
Each pack contains the tail and one x 1.6 stainless steel wire clamp.

 

Guaranteed
All PRACTool implements, including the CLAMP-IT Tail are covered by satisfaction guarantee, giving you absolute peace of mind.

Find a dealer

Back to blog